Electrolux GA60GXI203 User Manual page 27

1)
It comes on when it is necessary to fill the salt container. Refer to 'Use of dishwasher
Salt
salt'.
After you fill the container, the salt indicator light can stay on for some hours. This
does not have an unwanted effect on the operation of the appliance.
1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while
a washing programme operates.
Programme selection button
With this button you can select the washing
programme. Press the button again and
again until the display shows the number of
the necessary programme.
Refer to 'Washing programmes' for more da-
ta about the washing programmes.
Half-load button
Use this function when it is necessary to start
a washing programme with baskets not fully
load.
The half-load function decreases the time
duration and the consumption of water and
energy.
Put the dishes in the upper and lower basket
and decrease the detergent dosage when
you use this function.
Set the half-load function only before the
start of a washing programme. It is not pos-
sible to set the function while a washing pro-
gramme operates.
The half-load function is not available for all
washing programmes. Refer to 'Washing
programmes'.
Press the half-load button. If the function is
available, the related indicator light comes
on .
Sanitize button
This function gives more hygiene to dishes
and glasses. During the last rinse, the tem-
perature increases to 68°C and stays above
65°C minimum for 10 to 14 minutes.
Set the sanitize function only before the start
of a washing programme. It is not possible to
set the function while a washing programme
operates
The sanitize function is not available for all
washing programmes. Refer to 'Washing
programmes'.
Press the sanitize button. If the function is
available, the related indicator light comes
on.
Indicator lights
Extra-rinse button
This function adds one more cold rinse to the
washing programme. The programme dura-
tion and the water consumption increase.
Set the extra-rinse function before the start
of a washing programme. It is not possible to
set the function while a washing programme
operates.
The extra-rinse function is not available for all
washing programmes. Refer to 'Washing
programmes'.
Press the extra-rinse button. If the function is
available, the related indicator light comes
on.
Multitab button
Press this button to activate/deactivate the
multitab function. Refer to 'Multitab function'.
Delay start button
Use this button to delay the start of the wash-
ing programme with an interval between 1
and 19 hours. Refer to 'Select and start a
washing programme'.
Display
The display shows:
• The electronic adjustment of the level of
the water softener.
• Activation/deactivation of the rinse aid dis-
penser (only with multitab function on).
• The number of the washing programme.
• Remaining time to the end of the washing
programme.
• The end of a washing programme. The
display shows a zero.
• Remaining time to the end of the delay
start.
• Fault codes.
Function buttons
Use the function buttons for these opera-
tions:
• To adjust electronically the level of the wa-
ter softener. Refer to 'Setting the water
softener'.
electrolux 27