Water hardness
°dH
°TH
51 - 70
91 - 125
43 - 50
76 - 90
37 - 42
65 - 75
29 - 36
51 - 64
23 - 28
40 - 50
19 - 22
33 - 39
15 - 18
26 - 32
11 - 14
19 - 25
4 - 10
7 - 18
< 4
< 7
1) Factory position.
2) No use of salt is necessary.
You must adjust the water softener man-
ually and electronically.
Manual adjustment
Turn the water hardness dial to the position
1 or 2 (refer to the chart).
Electronic adjustment
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
Use of dishwasher salt
Do these steps to fill the salt container:
1. Turn the cap counterclockwise to open
the salt container.
2. Fill the salt container with 1 litre of water
(only with the first operation).
3. Use the funnel to fill the salt container with
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
mmol/l
Clarke
9,1 - 12,5
64 - 88
7,6 - 9,0
53 - 63
6,5 - 7,5
46 - 52
5,1 - 6,4
36 - 45
4,0 - 5,0
28 - 35
3,3 - 3,9
23 - 27
2,6 - 3,2
18 - 22
1,9 - 2,5
13 - 17
0,7 - 1,8
5 - 12
< 0,7
< 5
Water hardness adjustment
manually
1)
2
1)
2
1)
2
1)
2
1)
2
1)
2
1
1
1
2)
1
3. Press and hold function buttons B and C
until the indicator lights of function but-
tons A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function buttons
B and C go off.
– The indicator light for function button A
continues to flash.
– The display shows the current adjust-
ment.
Example: the display shows
5.
6. Press the function button A again and
again until the display shows the neces-
sary adjustment.
7. Press the on/off button to keep the op-
eration.
It is correct that water comes out from
the salt container when you fill it with salt.
If the water softener is set electronically
to the level 1, the salt indicator light stays
off.
electrolux 29
electronically
10
9
8
7
6
1)
5
4
3
2
2)
1
= level