Dhcp Client - D-Link DIR-430 User Manual

DIR-430 RangeBooster G Wireless Router User's Guide
D HCP client
If the option selected is DHCP client, the DIR-430 tries to get the IP address
automatically from the Internet. This requires a DHCP Server running on the
network connected to your Internet Port.
configuration while the progress bar is displayed on your browser.
Once successful, your quick setup is complete. You are ready to use the Gateway.
Proceed to Advanc
over the Gateway.
Once DHCP client successfully receives the IP address from the ISP, the HT
configuration dis
Insert pic here
In case the Gateway fails to get an IP address, it shows an error on the screen.
You may press <Previo
Internet access setting.
MAC cloni
required.
After the DIR-430 gets the new IP information, you are allowed to change ISP
served DNS server IP addresses at any time by clicking
click on the hyper-link, it is prompted to enter new DNS server IP address as
shown below.
This facility helps yo
server inf
ed Configuration section in this document for custom control
plays IP address information as shown in the following image.
us button and try again, or change the mode of the
ng is disabled by default. Please see Section on MAC cloning if
u add custom DNS servers, or if ISP doesn't not provide DNS
ormation.
Page 26 of 103
Version : 1
You should no t disturb the
here hyper-link. Once you
.0
ML