Static Ip; Pppoe - D-Link DIR-430 User Manual

DIR-430 RangeBooster G Wireless Router User's Guide
S tatic IP
User can choose to set the External Network address to be static IP address,
when the ISP offers you static/permanent IP address through a cable modem,
DSL or a dial-up connection. The IP address does not have to change upon the
rebooting of the device. As shown in the figure below, fill i
address, subnet mask and Gateway IP address as given by ISP.
P PPoE
Some DSL service providers use PPPoE (Point-to-Point Protocol over Ethernet) for
Internet access for their end-users. Please check with your ISP whether PPPoE is
used for your Internet access. Provide PPPoE u
ISP in the configuration page as shown below.
Once configured, the DIR-430 is always connected to the Internet. If you would
like to have Internet access to be available only on Demand, you can select the
option "Connect on Demand" on this page. By default, the Maximum idle time
allowed before the Gatew
configure your own value.
ay disconnects the Internet is 10 seconds. You may
Page 27 of 103
Version : 1
n the details, IP
ser name, password given by your
.0