Procedure; Programming The Transponder; Assignment Of Pins And Transponders - Simons Voss Technologies TRA.PINCODE User Manual

Page 9
It is not possible to enter programming mode when there is a battery warning. This
means that it is not possible to change or delete PINs when there is a weak battery.
Programming mode will only be available again after you have successfully
changed the battery (see the section "Battery Replacement).
5.2

Procedure

Input "1"
(for PIN 1)
6.0

Programming the Transponder

6.1

Assignment of PINs and Transponders

• PIN1 ⇒ Transponder 1
• PIN2 ⇒ Transponder 2
• PIN3 ⇒ Transponder 3
Each integrated transponder has its own transponder ID (TID); the TIDs are saved in
the SimonsVoss locks as part of the audit trail. In this way, you have a record of
which PIN was used to gain access and when.
Wireless Keypad: TRA.PINCODE
Input "0"
Input "master PIN"
Input "2"
(for PIN 2)
Input PIN length "0"
Input "3"
(for PIN 3)