Download Print this page

BART LAB-DMM Operating Manual page 14

Digital manometer

Advertisement

I
Manuale Operativo
valore sul display.
MENU dei PARAMETRI
Per entrare nel menu di configurazione mantenere premuto il tasto SET per
circa 3 secondi, fino alla comparsa del primo parametro (Unit per scelta
unità di misura). Premere sempre SET per passare ai parametri successivi e
quindi per uscire. Dopo l'ultimo parametro il tasto SET determina il
salvataggio dei parametri con ritorno alla modalità di misura. I nuovi valori
eventualmente impostati divengono quindi attivi all'uscita dal menu di
configurazione.
UNITÀ DI MISURA
Unit
In questo passo è possibile cambiare l'unità di misura
agendo sui tasti
FILTRO DIGITALE
In questo passo è possibile variare l'effetto Filtro
digitale. Aumentando il valore XX aumenta l'effetto di
filtro, permettendo all'utente di rilevare il valore medio
FL XX
di pressioni instabili o pulsanti. I valori selezionabili sono
da 0 a 99. Questa funzione agisce anche sulla velocità di
conversione del display, pertanto se si vogliono rilevare
picchi è consigliabile diminuire al minimo l'effetto del
filtro.
e .
MO.LabDMM.537.R3
the display.
PARAMETERS MENU
To enter into the setting menu keep pressed the SET key for approx. 3
seconds, until the first parameter appears on the display (Unit to choose
the measurement unit). Press always SET to move to next parameter, and
then to exit from the setting menu. After the last parameter the SET key
saves the parameters, then comes back to the measurement mode. The
new values, eventually set, becomes therefore active at the exit from
setting menu.
MEASUREMENT UNIT
Unit
In this step it is possible to change the measurement
unit through the keys
DIGITAL FILTER
In this step the operator can change the Digital Filter
effect. By increasing the XX value the filter effect
increases enabling the operator to find out the average
FL XX
value of unsteady or pulsating pressures. Selectable
values go from 0 up to 99. This function also acts on
display conversion speed, therefore if peaks shall be
detected it is recommendable to decrease the filter
effect at its minimum.
page 13
Operating Manual
GB
and
.

Advertisement

loading
Need help?

Need help?

Do you have a question about the LAB-DMM and is the answer not in the manual?