I
Manuale Operativo
PROGRAMMAZIONE PARAMETRI
Lo strumento può essere programmato tramite il MENU dei parametri:
Unità di Misura.
Filtro Digitale.
Risoluzione.
Tempo di Auto Spegnimento.
Zero (solo per pressioni ASSOLUTE)
Baud rate RS-232.
MESSAGGI DI ERRORE
UUUUU
SOVRAPRESSIONE: il manometro misura una pressione
superiore alla sua portata nominale.
LLLLL
SOVRAPRESSIONE in VUOTO: il manometro misura una
depressione superiore -1bar.
ATTENZIONE: dopo una SOVRAPRESSIONE verificare che la
calibrazione non si sia alterata.
HHHHH
FUORI SCALA: cambiando unità di misura succede che la
misura supera il limite numerico del display 99999. Cambiare scala.
LOBAT
BATTERIE SCARICHE: Le misure effettuate in questo stato
possono essere alterate, pertanto è necessaria la sostituzione delle pile.
MO.LabDMM.537.R3
PARAMETERS PROGRAMMING
The instrument can be programmed through the parameters MENU:
Measurement unit.
Digital Filter.
Resolution.
Power Off Time.
Zero (only for ABSOLUTE pressure)
Baud rate RS-232.
ERROR MESSAGES
UUUUU
OVERPRESSURE: the manometer is measuring a pressure
higher than its nominal rate.
LLLLL
VACUUM OVERPRESSURE: the manometer is measuring a
vacuum higher than –1 bar.
WARNING: after that high OVERPRESSURE occurred, the
calibration could have been altered
HHHHH
OUT SCALE: when the unit of measurement is changed, the
reading may exceed the numerical limit of the scale, 99999. Change scale.
LOBAT
EXHAUSTED BATTERIES: Measurements performed during this
period could be altered, it is therefore necessary to replace the battery
quickly.
page 11
Operating Manual
GB
Need help?
Do you have a question about the LAB-DMM and is the answer not in the manual?