Schaudt Booster WA 121545 Operating Instructions Manual page 46

Operating Instructions Booster WA 121545
8.4.2
20
Press the "Set" button (Figure 11, Pos. 2) for longer than 3 seconds.
"
The LED of the newly set battery type lights permanently.
F
The newly set battery type is saved.
F
ATTENTION!
Y
Once the setting is complete, check as in Section 8.3 whether the settings
have been completed correctly.
Setting the "Power Reduct." characteristic C1 ... C4
ATTENTION!
Y
The correct characteristic selection is dependent on the generator available.
So therefore:
check before adjusting the setting which generator type is fitted in the
F
vehicle (consult with the chassis manufacturer if required)
The corresponding characteristic defines the lower voltage threshold
F
from which no more charging takes place (i.e. no more current is
drawn from the generator), and the upper voltage value from which
the maximum charge current can flow (into the leisure area battery).
Turn off the vehicle engine.
"
Keep pressing the "Display" (Disp.) button (Figure 11, Pos. 1) until the
"
LED above the "Power Reduct." column lights.
The LED above the "Power Reduct." column lights.
F
Lighting in the left-hand column is the LED of curve C1 to C4 currently
F
set (Characteristic 1 ... 4).
Within 6 seconds, press the "Set" button (Figure 11, Pos. 2) for longer
"
than 3 seconds.
The LED above the "Power Reduct." column flashes.
F
The LED of curve C1 to C4 currently set (Characteristic 1 ... 4) flas-
F
hes.
Keep pressing the "Set" button (Figure 11, Pos. 2) until the LED of curve
"
C1 ... C4 required flashes:
I (A)
L
I
max
0
10 10,5
Fig. 12 Charge current reduction characteristic C1 to C4 (values are example and may differ
depending on vehicle manufacturer)
Date: 21.09.2017
11,8 12,4 12,6
C2
C3
C1
12 12,5
11 11,5
11,2 11,8 12,6
13,2
C4
13 U (V)
E
13,2
8200510 BA / EN