Adjustments; Control And Display Panel - Schaudt Booster WA 121545 Operating Instructions Manual

8.1
4
3
8200510 BA / EN
8

Adjustments

Control and display panel

Fig. 11 Control and display panel for adjustments and display
1 "Display" button (Disp.)
2 "Set" button (with sticker over it when delivered)
3 "Adjustments" display panel
4 "Charge and device status" display panel
The functions of the control and display panel:
Display of the current charge and device statuses (Figure 11, Pos. 4),
F
charge cycle and charge current
On request, display of the current settings (Figure 11, Pos. 3)
F
Battery type "Batt. Type", power reduction characteristic "Power Re-
duct." and maximum possible output current "Max. Output"
Change settings
F
ATTENTION!
Y
Before initial use, the conditions in the vehicle must be determined
and taken into account (fuse and cable cross sections). The installa-
tion of the boosters requires expert knowledge in the field of vehicle
and suspension electronics.
In case of doubt, the booster should be installed by a qualified specia-
list company.
Default settings when delivered:
Y
Part no. Batt.-Type
9200510
9200512
ATTENTION!
Y
To change the settings, use a sharp object made of insulting material (such
as a toothpick) to pierce the gummed label above the "Set" button inside the
circle, and use it to press the button behind.
Date: 21.09.2017
Operating Instructions Booster WA 121545
Power reduct.
C1 (Power limitation
Acid
characteristic 1)
C3 (Power limitation
AGM
characteristic 3)
1
2
Max. Output
45 A
70 A
17