Adjusting The Primary Air Flow; Reassembling The Hob Skin; Adjusting The Minimum Setting For Natural Gas And Town Gas; Adjusting The Minimum For Bottled Gas - Smeg PTS723-3 Instructions For Use Manual

Smeg range instructions for use

Hide thumbs

Table of Contents

5.5

Refers to the gap "X" in mm.

BURNER

Semi rapid (1)

Rapid (2)

Ultra-Rapid (3)

To identify the burners on your hob, refer to the drawings in point "5.8 Hob burner

layout"

5.6

Reverse the procedure described in point "5.1 Removing the hob skin ".

When replacing the burner rings, bear in mind that they must be fully tightened using

the spanner provided.

Put the pan stands back in place, fitting first those at the side and then the central one.

5.7

Reassemble the components on the burner and fit the

knobs onto the tap rods.

Light the burner and turn it to the minimum

Remove the knob again and adjust the regulator

screw inside or beside the tap rod (depending on the

model) until an even minimum flame is obtained.

Put the knob back in place and check the stability of

the burner flame (the flame must not go out when the

knob is turned quickly from the maximum to the

minimum setting).

5.8

To adjust the minimum level when using bottled gas, the adjuster screw inside or

beside the tap rod must be turned fully clockwise (depending on the models).

The diameters of the bypasses for each individual burner are stated in point "5.2

Adjusting for bottled gas".

After adjusting for use of a gas other than the gas used for testing the appliance,

replace the label on the casing with the label for the new gas. The label is supplied in

the bag with the LPG nozzles (G30 ˆ G31).

Instructions for the Installer