After Starting; Normal Starting - Diesel Engine - Lancia Voyager 2014 Owner's Handbook Manual

WARNING!
(Continued)
• If the vehicle has a discharged
battery, booster cables may be
used to obtain a start from a
booster battery or the battery in
another vehicle. This type of start
can be dangerous if done improp-
erly. Refer to "Jump Starting" in
"What To Do In Emergencies" for
further information.
Clearing A Flooded Engine (Using
ENGINE START/STOP Button)
If the engine fails to start after you
have followed the "Normal Starting"
or "Extreme Cold Weather" proce-
dures, it may be flooded. To clear any
excess fuel:
1. Press and hold the brake pedal.
2. Press the accelerator pedal all the
way to the floor and hold it.
3. Press and release the ENGINE
START/STOP button once.
The starter motor will engage auto-
matically, run for 10 seconds, and then
disengage. Once this occurs, release the
234
accelerator pedal and the brake pedal,
wait 10 to 15 seconds, then repeat the
"Normal Starting" procedure.
Clearing A Flooded Engine (Using
Fob With Integrated Key)
If the engine fails to start after you
have followed the "Normal Starting"
or "Extreme Cold Weather" proce-
dures, it may be flooded. To clear any
excess fuel:
1. Press the accelerator pedal all the
way to the floor and hold it.
2. place the ignition in the START
position and release it as soon as the
starter engages.
The starter motor will disengage auto-
matically in 10 seconds. Once this oc-
curs, release the accelerator pedal, turn
the ignition switch to the LOCK posi-
tion, wait 10 to 15 seconds, then repeat
the "Normal Starting" procedure.
CAUTION!
To prevent damage to the starter,
wait 10 to 15 seconds before trying
again.

AFTER STARTING

The idle speed is controlled automati-
cally and it will decrease as the engine
warms up.
NORMAL STARTING –
DIESEL ENGINE
1. Turn the ignition switch to the ON
position.
2. Watch for the "Wait To Start
Light" in the instrument cluster. Refer
to "Instrument Cluster" in "Under-
standing Your Instrument Panel" for
further information. It will illuminate
for two to ten seconds or more, de-
pending on engine temperature.
When the "Wait To Start Light" goes
out, the engine is ready to start.
3. DO NOT press the accelerator.
Turn the ignition switch to the START
position and release when the engine
starts.