Pressure Washer TABLE OF CONTENTS DANGER Safety Rules ........2-3 Running engine gives off carbon monoxide, an Assembly .
Page 3
Pressure Washer WARNING WARNING Gasoline and its vapors are extremely Starter and other rotating parts can entangle flammable and explosive. hands, hair, clothing, or accessories. Fire or explosion can cause severe burns or death. • DO NOT wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts.
Page 4
Pressure Washer IMPORTANT: Read entire owner’s manual before you attempt NOTE: It may be necessary to move the handle supports from to assemble or operate your new pressure washer. side to side. • Insert the carriage bolt through the hole on the right side of REMOVE PRESSURE WASHER the handle (viewing from front of unit) and attach the plastic FROM CARTON...
Pressure Washer • Slowly add "UNLEADED" regular gasoline to fuel tank. Use a Figure 5 — Install Oil Dipstick onto the Pump funnel to prevent spillage. Slowly fill tank to about 1.5" below the top of the filler neck (Figure 6). Shipping Cap Remove shipping cap and Figure 6 —...
Pressure Washer • If your unit is supplied with quick connects on the high • Check that oil has been added to the proper level in the pressure hose and pump, attach the other end of the high engine crankcase. pressure hose to the high pressure outlet on the pump •...
Pressure Washer How to Stop Your Pressure Washer • Twisting the nozzle adjusts the spray pattern from a narrow pattern to a fan pattern (Figure 14). • Turn engine off according to the engine owner’s manual. Figure 14 — Adjusting the Nozzle for Spray Pattern •...
Pressure Washer Always start the turbo nozzle at a distance, gradually getting After you have applied detergent, scour the surface with the high closer to the surface until you get the cleaning force you want. pressure water stream and then rinse it clean, as follows: •...
Pressure Washer GENERAL MAINTENANCE Place the o-ring into the recess. Push the o-ring snugly against the in-line filter screen. RECOMMENDATIONS Assemble the nozzle extension to the spray gun, as described The pressure washer warranty does not cover items that have earlier.
Pressure Washer • Using a garden hose, remove additional debris by back flushing Figure 17 — Remove and Clean Nozzle water through the nozzle extension (Figure 20). Back flush between 30 to 60 seconds. Figure 20 — Backflushing the Nozzle Extension Nozzle •...
Pressure Washer Pump Maintenance ENGINE MAINTENANCE See the engine owner’s manual for instructions on how to For Model 01778 (2400 PSI): properly maintain the engine. Changing Pump Oil CAUTION! Avoid prolonged or repeated skin contact Change oil every 50 hours or once yearly, whichever occurs first. with used motor oil.
Pressure Washer TROUBLESHOOTING Problem Cause Correction Low pressure nozzle installed or Replace nozzle with high pressure nozzle nozzle in low pressure mode. or pull nozzle backward for high pressure. Water inlet is blocked. Clear inlet. Pump has following Inadequate water supply. Provide adequate water flow.
BRIGGS & STRATTON POWER PRODUCTS OWNER POLICY Effective June 1, 2002 LIMITED WARRANTY “Briggs & Stratton Corporation will repair or replace, free of charge, any part, or parts of the equipment**that are defective in material or workmanship or both.Transportation charges on parts submitted for repair or replacement under this warranty must be borne by purchaser.This warranty is effective for the time periods and subject to the conditions provided for in this policy.
Need help?
Do you have a question about the BPW2400 and is the answer not in the manual?
Questions and answers