Assembly; Unpackpressurewasher; Attach Handle And Accessory Tray - Briggs & Stratton Brute Operator's Manual

Your pressure washer requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and fuek
if you have any problems with the assembly of your pressure
washer, pleasecall the pressure washer helpline at
(800) 743-4115. if calling for assistance, please havethe
model, revision, and serial number from the identification
label available,
UnpackPressureWasher
1, Removethe parts bag, accessories, and inserts
included with pressure washer.
2, Open caCLon completely by cutting each corner from
top to bottom,
3, Ensureyou have all included items prior to assembly,
items in the carton include:
o Main Unit
o Handle
o High Pressure Hose
o Spray Gun
o NozzleExtension with Quick Connect Fitting
o Plastic Accessory Tray
o Oil Bottle
o Parts Bag (which includes the following):
o Operator's Manual
o Owner's Registration Card
o Bag of 4 Multi-Colored Quick Connect Spray Tips
o Handle/AccessoryTray FasteningHardware Kit
(which includes):
o Carriage Bolts (2)
o Plastic Knobs (2)
o Tree Clips (4)
To prepare your pressurewasher for operation, you wiii
need to perform these tasks:
1, Fill out and send in registration card,
2. Attach handle and accessory tray to main uniL
3, Add oil to engine crankcase,
4, Add fuel to fuel tank,
5. Connect high pressure hose to spray gun and pump,
6, Connect water supply to pump,
7, Attach nozzle extension to spray gun,
8, Select/attach quick connect spray tip to nozzle
extension,
Attach Handle and Accessory Tray
1, Place handle (A) onto handle supports (B) connected to
main unit, Make sure hobs (C) in handle align with
hobs (C) on handle supports,
,
insert handle carriage bolts (D) through hobs from
inside of unit and attach a plastic knob (E) from outside
of unit, Tighten by hand, By loosening both knobs to
the middle section of the attachment bolt, the upper
handle can fold forward to store fiat atop the cold
engine,
/
NOTICE DO NOTfold handle down while the engine is hot.
3. Place accessory tray (F) over hobs (G) on handle
(viewing from back of unit), Push the tree clips (H) into
the hobs until they sit fiat against the accessory tray,
,
//
insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray,