How To Use Spray Tips; Applying Detergent - Briggs & Stratton Brute Operator's Manual

3. insert multi-colored spray tips in holes provided on
front of accessory tray.
4. Place one end of high pressure hose in groove at top of
accessory tray and wrap high pressure hose around
hooks as shown.
How to Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger is locked. The spray tips vary the spray
pattern as shown.
Fallow these instructionsto change spray tips:
1. Pull back collar on quick-connect and puff current
spray tip offi Store spray tips in holder provided on the
nozzle extension.
WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
* NEVER exchange spraytips withoutthetriggerlock being
engaged on the spraygun.
* DONOT twist spraytips whilespraying.
2. Select desired spray tip:
Low Pressure
Black
Use to apply
detergent
40° White
21O0 PSI
2.3 GPM
15° Yellow 0° Red
2600 PSI
2.1 GPM
° For gentle rinse, select white 40° spray tip.
o To scour surface, select yellow 15° or red 0° spray tip.
o To apply detergent, select black spray tip.
3. Pul back on collar, insert new spraytip and releasecollar.
Tug on spray tip to make sure it is securelyin place.
Usage Tips
* For most effective cleaning, keep spray tip from 8 to
24 inches _20 to 61 cm) away from cleaning surface.
o if you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
o DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
Applying Detergent
A WARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in death,
serious injury, and/or property damage.
* DO NOTuse caustic liquid with pressure washer.
* Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Ta apply detergent, fallow these steps:
1. Review use of spray tips.
2. Prepare detergent solution as required by job.
3. Place end of detergent siphoning tube into detergent
container.
NOTICE Make sure the tube is fully submerged in detergent
while applying detergent.
13