How To Use Accessory Tray; Low Pressure; High Pressure; How To Use Spray Tips - Briggs & Stratton PowerBoss Operator's Manual

Hide thumbs Also See for PowerBoss:
Table of Contents

Advertisement

Available languages

Available languages

WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places
to store your spray gun, nozzle extension and high
pressure hose.
NOTICE The extra hole in the tray is for storing a
utility brush. The extra clip in the tray is for storing a
turbo nozzle. The brush and turbo nozzle are NOT
included with your pressure washer. You can buy
these items as optional accessories.
1. Place nozzle extension through hole on accessory
tray, as shown.
2. Place spray gun through hole on accessory tray
on right side of unit.
3. Hang high pressure hose on hook attached to
handle, as shown.

How to Use Spray Tips

The quick–connect on the nozzle extension allows you
to switch between four different quick connect spray
tips. Spray tips can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
spray tips vary the spray pattern as shown below.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
• NEVER exchange nozzles without the trigger lock being
engaged on the spray gun.
• DO NOT twist nozzles while spraying.
2. Select desired spray tip:

High Pressure

40° White
15° Yellow
• For gentle rinse, select white 40° spray tip.
• To scour surface, select yellow 15° or red 0° spray
tip.
• To apply detergent, select black spray tip.
3. Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
Usage Tips
• For most effective cleaning, keep spray tip from
8 to 24 inches (20 to 61 cm) away from cleaning
surface.
• If you get spray tip too close, especially using a
high pressure spray tip, you may damage surface
being cleaned.
• DO NOT get closer than 6 inches (15 cm) when
cleaning tires.

Low Pressure

Black
Use to apply detergent
0° Red
13

Advertisement

Chapters

Table of Contents
loading

Table of Contents