Genius LuxeMate T830 User Manual

Hardware Installation

1. Install one AAA battery into the mouse and two AA into the
keyboard.
2. Plug in your USB receiver to a USB port of your PC.

Software Installation

1. Place your CD driver in your PC drive for
software installation.
2. Follow the instructions on the screen to
finish the software installation.

Replace Batteries

If the mouse or keyboard does not work
properly, then the batteries have lost their charge, so you need to
replace them.
Warning: do not mix or use different types of batteries at the same
time.

ID Channel Setting and connection:

Follow these steps:
1. The micro dongle is stored inside of the mouse, plug it into a USB
port and wait about 5-10 seconds.
2. Press the connect button on the mouse first, then the keyboard.
3. The connection will be executed and the kit will be ready for use.

Warning (Trouble shooting)

1. Some of keyboard buttons may not work until the driver has been
installed. We recommend you install the driver first before you
use this product.
2. To re-program other media programs, software installation is
required.
3. In case the wireless device was not connected when you set the
ID channel setting, check if you have installed the batteries with
the positive (+) and negative (-) polarity in the correct position,
then repeat the ID channel setting again.
4. For optimum performance, please make sure that the distance
between the wireless device and the micro dongle receiver does
not exceed 10M.

Important Notice:

The factory default for the sleep mode function is around 15 minutes
without usage; just press any key to wakeup the touch-panel.
ENGLISH
1