Table of Contents
Advertisement
5-4
Chapter
5
Camera and Lighting Parameters
Selecting
Camera Type/Mode
Popup Menu
(continued)
Your Action
Comments
Pick the appropriate box in
the Camera Type/Mode
popup menu.
Selecting Shutter Parameter
Your Action
Look at the Shutter
menu
box in the Camera
popup menu.
l
Frame Reset Camera: Selects a frame reset camera.
Using the frame reset camera, the CVIM system can reset
the camera's image sensor, and the camera can then begin
acquiring a new image immediately.
NOTE:
If you select Frame Reset Camera and intend to use
two cameras, both must be frame reset cameras.
When you pick the box, the new selection will be highlighted
in the Camera Type/Mode
popup menu.
Ifyou selected Standard
Camera or Std. Cam., DTR Mode in
the Camera Type/Mode
popup menu, skip this step.
Ifyou selected Frame Reset Camera in the Camera
Type/Mode
popup menu, you must set the Shutter parameter
(in microseconds)
to the same shutter speed that you set on
the frame reset camera.
NOTE:
If your application uses two frame reset cameras,
both must be set to the same shutter speed.
To determine the correct shutter speed setting for the
camera(s) used in your application,
refer to the camera user
manual.
Comments
The 5 h utter menu box displays the currently selected
value for the shutter parameter.
NOTE:
The allowable range of values for the shutter
parameter is 400 to 16,667. If you try to enter a number less
than 400, the number in the Shutter menu box will remain
(or change to) 0 (zero), which is the default value.
Advertisement
Table of Contents
