Installing The Smartline Element - Miele CS 7612 User Manual

Installation
Natural stone worktops
You will need heavy-duty double-
sided tape (not supplied) to secure the
spacer bars.
 Stick the tape onto the upper edge of
the cut-out or onto the lower step of
the stepped cut-out.
 Position the spacer bars flush onto
the upper edge of the cut-out or onto
the lower step of the stepped cut-out.
 Press the spacer bars firmly into
place.
66
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Installing the SmartLine ele-
ment
 Stick the supplied sealing strip under
the edge of the SmartLine element.
Do not apply the sealing strip under
tension.
 Feed the mains connection cable
down through the cut-out.
 Position the SmartLine element in the
worktop cut-out. When doing this
make sure that the seal of the appli-
ance sits flush with the worktop on all
sides. This is important to ensure an
effective seal all round.
Onset installation
 If the seal does not meet the worktop
correctly on the corners, carefully
scribe the corner radii (≤ R4) with a
jigsaw.
Do not use any additional sealant
(e.g. silicone) on the SmartLine ele-
ment.
 Connect the SmartLine element to
the mains.
 If required, connect the SmartLine
element to the gas supply (see "Gas
connection").
 Check that the SmartLine element
works.
 Seal the gaps between the individual
elements with a silicone sealant that
is heat-resistant to at least 160 °C.