Miele CS 7612 User Manual page 46

Problem
Power level 9 is auto-
matically reduced if you
select power level 9 on
two linked cooking
zones at the same time.
The food in the pan
does not heat up when
the Auto heat-up func-
tion is switched on.
An operating noise can
be heard after the
SmartLine element has
been switched off.
The sensor controls
show increased sensit-
ivity or fail to react.
 flashes alternately
with  in the timer dis-
play and a tone will
sound.
1 and a number, e.g. 1-0
flashes alternately with
a 3 digit number in the
timer display.
Cause and remedy
Operating both zones at power level 9 would exceed
the permitted maximum power for the two zones.
 Use a different cooking zone.
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
The cooling fan runs until the SmartLine element has
cooled down and then switches off automatically.
The sensitivity level of the sensor controls has
changed.
 Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the Smart-
Line element. The area surrounding the SmartLine
element must not be too dark.
 Take any pans off the SmartLine element and wipe
away any food deposits.
Ensure that there is nothing covering the entire
SmartLine element unit or sensor controls.
 Interrupt the power supply to the SmartLine ele-
ment for approx. 1 minute.
 If the problem persists after power has been re-
stored, please contact Miele Service.
The SmartLine element is connected incorrectly.
 Disconnect the SmartLine element from the mains.
 Contact Miele Service.
Cooking zone fault
 Interrupt the power supply to the SmartLine ele-
ment for approx. 1 minute.
 If the problem persists after power has been re-
stored, please contact Miele Service.
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Problem solving guide
45