Wireless Communication - Nacon REVOLUTION Unlimited Pro Controller User Manual

EN /
NOTES:
- The 'Mode Selection' switch on the back determines if the controller is working
in PS4™ Normal Mode (Position 1) or PS4™ Advanced Mode (Position 2).
- The PC Advanced Mode (Position 3) allows to switch your controller into the
X-Input Mode for PC* use.
b.

Wireless communication

Ensure that the wireless communication mode is selected and follow these
steps:
- Connect the USB Bluetooth
- The receiver LED will flash to show that it is searching for a controller.
- Press the PS button on your controller. The LED player status indicator will
light up. Please note the player status indicator can react to in-game action, if
supported by the software.
- The receiver LED will stop flashing when connected to the controller and will
display the same colour as the LED player status indicator on the controller.
- You are now ready to play.
NOTES:
- If the controller is not connecting, to the USB Bluetooth
to synchronise the controller to the receiver. The process is:
• ensure that the controller is OFF or turn it OFF,
• press and hold 'Share' + 'PS' buttons, on your controller, until the LED player
status indicator starts to flash,
• press the SYNC button on the USB Bluetooth
- If you are connecting a 2nd controller, to a free USB socket, then connect 1x
controller and 1x USB Bluetooth
- If you leave your controller, for more than 10 minutes, it will go in to 'Sleep'
mode. It can be woken up by pressing on the 'PS' button.
- To switch off your controller, press and hold the 'PS' button, for 6 seconds, until
the controller powers OFF.
- When switching from Wireless mode to Wired mode you will see the on-screen
message: 'Controller was disconnected'. Press the 'PS' button to re-connect.
- If, during gameplay, you experience any latency or deactivation then please
adjust your USB receivers in the way shown below:
receiver into a free USB port on PS4™ system.
®
receiver first followed by the 2nd.
®
receiver, you may have
®
receiver (the sync LED will flash).
®