Inlet Valve Removal And Replacement - EdgeStar DWP62BL Service Manual

Inlet Valve Removal and Replacement

The inlet valve controls the inflow of water into the dishwasher. The valve opens and closes to allow
water into the unit based on signals from the control board.
Tools Needed:
- Phillips Screwdriver
- Gear drive hose clamp (1)
Step 1: Remove Base Tray Cover

Refer to instructions to remove panel found in the "Drain Pump Removal and Replacement"
section of this document
Step 2: Remove and replace the inlet valve assembly

Remove the electrical connectors from the inlet valve and place to the side.

Use a flat tip screwdriver to pry the clips securing the ends of the hose clamp together. Remove
and discard clamp.

From the outside of the unit, push the yellow snap latch towards the inside of the unit, turn and
line up with the latches to remove.
- Flat Tip Screwdriver - Needle nose pliers
40