Float Assembly, Float Micro Switch And Float Removal And Replacement Instructions - EdgeStar DWP62BL Service Manual

Float Assembly, Float Micro Switch and Float Removal and
Replacement Instructions
Tools Needed:
- Phillips Screwdriver
Step 1: Remove Base Tray Cover

Refer to instructions to remove panel found in the "Drain Pump Removal and Replacement"
section of this document
Step 2: Remove the float assembly cover

Pinch the two cylindrical latches and slide the cover up over the clips exposing the Styrofoam
float
Step 3: Remove and replace the micro switch

Using needle nose pliers and push against the two grey latches to release the micro switch

Slide the new micro switch into the latches in the same orientation
NOTE: If replacing the Styrofoam float itself, simply lift the float over the cylindrical latches and slide the
new float into place
- Flat Tip Screwdriver - Needle nose pliers
33