EdgeStar DWP62BL Service Manual page 30

Circuit Board Removal and Replacement
There are three (3) circuit boards found within the dishwasher. Two of these boards are for display and
control panel functions and are referred to as 'Control Circuit Boards' or 'Display Circuit Boards'.
Additionally, there is a 'Power Circuit Board' that manages the power distribution within the unit.
Note: OEM Replacement board kits will include all 3 boards. All 3 boards should be replaced at the same time.
Tools and Parts Needed:
- Phillips Screwdriver
Control Circuit Boards (Display Circuit Boards):
NOTE: The control boards are located behind the Control Panel Cover. Make sure you do not close the
door once the control panel cover is removed.
Step 1: Remove the Control Panel Cover

Open up the dishwasher and locate the 8 screws at the top of the inner door

Use a Philips hand screwdriver to remove these 8 screws
Tip: Hold the outside of the Control Panel Cover when removing the last screws so it does not fall. Do not pull on this
panel. The circuit board wiring harness will still be attached.
Step 2: Remove and Replace the control circuit boards
TIP: Take a photo of how the boards are placed and hooked up with the connectors for easy reinstall.
- Flat Tip Screwdriver - Needle nose pliers
29