EdgeStar DWP62BL Service Manual page 29


Slide the new check valve assembly into place
NOTE: The drain pump is keyed so the valve can only go in one way. It is easiest to start pushing it in
and slowly spin it until it slides over the keyway.

Check to make sure the valve is fully seated into the drain pump.
Step 4: Reinstall the drain hose

Slide a gear drive hose clamp over the end of the hose

Slide the hose over the connection on the drain pump

Tighten the hose clamp
Step 5: Reinstall the Base Tray Cover

Refer to instructions to reinstall Base Tray Cover found in the "Drain Pump Removal and
Replacement" section of this document
Gear Drive Hose Clamp
28