Change Unit Of Measure - LaserLiner DistanceCheck Manual

– Under no circumstances should optical instruments (magnifying glass,
microscope, binoculars) be used to look at the laser beam or reflections.
– Do not use the laser at eye level (1.40 ...1.90 m)
– Reflective, specular or shiny surfaces must be covered whilst laser
devices are in operation.
– In public areas shield off the laser beam with barriers and partitions
wherever possible and identify the laser area with warning signs.
– Tampering with (making changes to) the laser device is not permitted.
– This device is not a toy - keep out of the reach of children.
Switch on, measure and switch off:
device on
1x

Change unit of measure:

m / ft / inch / ft - inch
Delete the last
measured value:
Turn display:
Change measurement point (reference):
rear (device on)
!
To ensure correct measurements plug in pin so that it clicks
into position!
Change measurement function:
length
(device on)
1x
measure
2x
1 sec
1x
1 sec
1 sec
DistanceCheck
2x
pin
1 sec
1x
area
1x
device off
2 sec
1x
3 sec
1 sec
3 sec
front
1 sec
2x
volume
2x
GB
09