Change Of Batteries - LaserLiner BeamControl-Master BCM Operating Instructions Manual

BeamControl-Master BCM
Operation
Senso-
Commander
Note
Change of
batteries:
22
6.1.1 Using the SensorCommander as a laser receiver
Activation of the laser receiver mode:
Switch on the laser receiver mode. In order to ensure that the mode is
also activated on the BCM, direct the IR transmitting diode of the
SensoCommander at the BCM. Activation is indicated by lighting of LED
red/green and a signal sound on the SensoCommander.
Sound volume
+ Sound volume control
3 LED´s - max
2 LED´s - med
1 LED - min
only middle LED - sound off
Working with the SensoCommander
Hold the laser receiver with the reception field at the height of the rota-
ting laser beam. By means of LEDs and sound signals you will now find
the exact height of the laser level:
Top LED lights
Move SensoCommander downwards
Bottom LED lights
Move SensoCommander upwards
Middle LED yellow
Move SensoCommander slowly upwards or
downwards, respectively, until the middle LED
gives off green light
Middle LED green
SensoCommander exactly at laser level
Note:
When the middle LED gives off orange light, you are already within a 5 mm
range round the laser level (free-hand measuring). You will achieve a more
accurate result (fine measuring), when the SensoCommander is fixed (e.g.
onto a levelling staff). Then the green LED shows the exact centre.

Change of batteries:

Turn the turning knob on the bottom side and loosen it. Change batteries.
ENGLISH
Measuring distances
to SensoCommander
1 m – 120 m
Typ AAA