Advertisement
• Use POWER button to turn on A/C Analyzer.
• Use ▼ or ▲ buttons to highlight the date.
• Press ENTER.
• Use the ◄ or ► buttons to highlight the Day, Month, Year and Format.
• Use the ▲ or ▼ buttons to change the values.
NOTE: The format can be MM/DD/YYYY or DD/MM/YYYY.
• When correct press F1 to SAVE.
NOTE: Press F4 to EXIT without saving.
Set the Units
• Press the UNITS button at any time to toggle between Imperial and Metric units.
QUICK START
General Functions
(in most screens:)
• Press F3 (T/S) to go to the Test Selection screen.
• Press F4 (EXIT) to go to the Main Menu screen.
Testing using Quick Start
Quick Start allows you to use the A/C System Analyzer without entering a customer
or technician.
NOTE: Testing done in Quick Start mode will only be saved until the test is redone.
• Use power button to turn on A/C analyzer.
• Use the ▲ or ▼ buttons to highlight Quick Start.
• Press ENTER.
• Use ▼ or ▲ buttons to highlight the desired test.
• Press ENTER.
DB (DRY BULB)/WB (WET BULB)/RH (RELATIVE HUMIDITY)/
DP (DEW POINT)/ AIR VEL (AIR VELOCITY) WITH AIR VOLUME
OPTION TESTING
• For round vane meter, twist sensor cover to the Open position. For antenna
fan meter, go to next step.
• Insert cable into socket (it may take a few seconds for readings to appear).
• Place round vane meter or antenna fan meter perpendicular to airflow.
AIR VOLUME TESTING
• When in DB/WB/RH/DP/Air Vel testing screen Press ENTER.
• Use F2 (RECT/DIA) to toggle between rectangular and round duct.
• Use ► or ◄ buttons to highlight digit and ▲ or ▼ buttons to change digit value.
• Press ENTER to toggle between Height and Width.
NOTE: Be sure to press ENTER for both Height and Width before pressing done.
NOTE: In RECT mode you will enter Height and Width, but in DIA mode you will
enter the diameter only.
• Press F1 when DONE entering duct size.
• Place round vane meter or antenna fan meter perpendicular to air flow to read
volume.
TARGET SUPERHEAT TESTING
• Target Superheat Testing uses the round vane meter or antenna fan meter. For
round vane meter, twist sensor cover to the Open position. For antenna fan meter,
go to next step.
• Insert cable into socket (it may take a few seconds for readings to appear).
• Follow Target Superheat 1 screen instructions on where to place round vane meter
or antenna fan meter.
• When values have stabilized, press ENTER to save.
• Press F2 (NEXT).
• Follow Target Superheat 2 screen instructions on where to place round vane meter
or antenna fan meter.
• When values have stabilized, press ENTER to save.
• Press F2 (NEXT).
• Target Superheat will be displayed on the screen.
• If Actual Superheat has been tested, Press F1 (ANYL) for analysis.
TEMPERATURE SPLIT TESTING
• Temperature (TEMP) Split Testing uses the round vane meter or antenna fan
meter. For round vane meter, twist sensor cover to the Open position. For antenna
fan meter, go to next step.
• Insert cable into socket (it may take a few seconds for readings to appear).
3
Advertisement
