Method-B Procedure To Remove The Pole - A&D HV-C Series Instruction Manual

5.3.2.

Method-B Procedure to Remove the Pole

HV-300KC, HV-300KCP, HV-600KC, HV-600KCP,
HW-300KC, HW-300KCP, HW-600KC, HW-600KCP
Step 1 Turn the scale off.
Remove the AC adapter and batteries. .
Step 2 Open the rear cover of the display unit.
Gently disconnect the load cell cable connector
vertically. (Do not pull toward you).
Step 3 Using a Phillips screwdriver, remove four 4 mm
screws used to attach the display unit to the pole.
Step 4 Remove the ferrite core and the cable clamp from
the load cell cable.
Step 5 Carefully remove the load cell cable from the pole.
Take care not to pull on the connector forcibly.
Step 6 Arrange the cable so it does not touch the
weighing pan in the base unit.
If the cable is untied, the straight length of
L2-models is approximately 4.5 m. The length of
the optional extension load cell cable (HVW-02)
is approximately 5 m.
Step 7 Remove the pole and four hex screws from the base
unit using a hex wrench.
Step 8 Wind the cable through the ferrite core two times.
Affix the cable to the rear cover using the cable clamp.
Step 9 Connect the cable to the connector.
Close the rear cover.
Step 10 Check the weighing accuracy
Extension load cell cable (HVW-02)
Display unit
5 m extension cable
Page 16
Cable cover
Connector
4 mm screw
Step 7
Step 5
Base unit
Pole
The shape of base unit differs by model.
HV/HW-C/CP Series
Cable clamp
Load cell cable
Ferrite core
Wind up 2 times
Bracket cover
Hex wrench
Hex screws