Router Mode: Manage The Dhcp Server Address Pool - NETGEAR WAC124 User Manual

AC2000 802.11ac Wireless Access Point/Router WAC124
The NETGEAR Account Login page displays.
4. Enter your registered email address and password and click the LOG IN button.
The BASIC Home page displays.
5. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
6. In the IP Address fields, enter the new LAN IP address.
The LAN IP address at which you can access the local browser interface of the access
point/router also changes.
7. In the IP Subnet Mask fields, enter the new LAN subnet mask.
The LAN IP subnet mask at which you can access the local browser interface of the
access point/router also changes.
8. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address settings of the default LAN subnet, you are
disconnected from the local browser interface.
To reconnect, close your browser, relaunch it, and log in to the access point/router
at its new LAN IP address.

Router mode: Manage the DHCP server address pool

If the access point/router is in router mode, it functions as a Dynamic Host Configuration
Protocol (DHCP) server. The access point/router assigns IP, DNS server, and default
gateway addresses to all computers and mobile devices that are connected to its LAN
subnet.
These addresses are part of the same IP address subnet as the access point/router's
LAN IP address. The DHCP address pool for the LAN subnet is 192.168.0.2 through
192.168.0.254.
The access point/router delivers the following parameters to any LAN device that
requests DHCP:
• An IP address from the range that you define
• Subnet mask
• Gateway IP address
• DNS server IP address
Manage the Network Settings 114 User Manual