Rize Tranquility Owner's Manual page 10

Remote Control Guide
Understanding the remote control features
• The adjustable bed uses RF (radio frequency) 2.4 GHz remote control system.
• It is not necessary to face the receiver when operating the remote control. Remote signal is best transmitted
within 6.5 feet (2 meters) of the bed.
NOTE: The bed may show minor intermittent performance because of typical radio frequency interference.
This is normal in the operation of the bed, not a defect.
Pairing your remote control to your adjustable bed
Your adjustable bed is already paired to your remote control at the factory. Manual pairing is only needed for
replacement remote controls or to change tandem systems back to a single system.
NOTE: For the pairing to be successful, make sure the distance between the control box and the remote control
is not more than two (2) meters.
1
Make sure your bed is connected to a working electrical
outlet. A surge protector is recommended.
2
On the control box, press the pairing button twice. The LED
light turns on, and the control box is on pairing mode for 20
seconds.
3
On the remote control, press the
Down buttons at the same time until the LED light on
the control box turns off.
Your remote control is now successfully paired with your
adjustable bed.
10
Head Up and Head