NetComm Videotron 3G36W-V User Manual page 23

4.2.5 Advanced Routing
This page allows you to configure static and dynamic routing rules for your 3G36W-V.
4�2�5�1 Advanced Routing – Static
Static Routing allows computers that are connected to your 3G36W-V to communicate with computers on another LAN segment which
are connected to it via another router. To set a rule, you need to specify the following:
• Destination
• Subnet mask
• Gateway
• Interface
4�2�5�2 Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the 3G36W-V to adapt to changes in the network. RIP enables the device to determine
the best route for each packet based on the "hop count" or number of hops between Source and Destination. To enable Dynamic
Routing, select Enable from the drop box and click Apply.
4.2.6 DHCP Client List
This page allows you to view the current DHCP clients that have obtained IP leases from your 3G36W-V. The MAC address, assigned
IP address and the expiry period is shown for all computers who have automatically obtained addresses from the 3G36W-V. Please
note that this list is stored in the device's volatile memory, and is therefore cleared if the device is reset or if any changed are applied to
configuration.
www.netcomm.com.au
3G36W-V User Manual
3G36W-V User Guide
23