Installation; Installation Site And Environment; General - Alpha ESS M4856-P Installation Manual

2. Installation

This Manual introduces the basic steps how to install and operate AlphaESS M4856-P.
M4856-P is a sealed component with no access to battery terminals or cell components
within module.
M4856-P contains a Bi-pole DC isolator, which conforms to IEC 60947. It has been
operated in all live conductors
NOTE: please pay attention for unpacking the battery, the worst case
is that some components could be damaged.

Installation Site and Environment

General

The externals enclosure's material is SPCC. The material thickness is 1.0 mm.
The M4856-P has two versions, one is indoor, and another is outdoor. This M4856-P
(indoor version) can only be installed in an indoor location. ThisM4856-P (outdoor version)
can be installed in an outdoor or an indoor location.
Where battery systems are installed within a room, shall be located so that access to the
battery is not obstructed by the structure of the building, fixtures and fittings within the room.
M4856-P adopts natural ventilation. The location should be clean, dry and adequately
ventilated. The room's entry doors and panels shall open in the direction of egress and
allow unobstructed access to the battery for installation and maintenance purposes.
The following location are not allowed for installation:

habitable rooms;

in ceiling spaces;

wall cavities;

on roofs not specifically deemed suitable;

areas of access/egress;

under stairways;

under access walkways;

sites where the freezing point is reached, like garages, carports or other places;

sites with humidity and condensation over 85%;

sites which are salty and where humid air can penetrate;

earthquake areas –additional security measures are required here;

sites that are higher than 3000 meters above the sea level;

sites with explosive atmosphere;
______________________________________________________________________
Installation
Alpha ESS Co., Ltd.
Your Smart Energy
Page 11 of 29