Nice M3BAR Instructions And Warnings For Installation And Use page 12

only for booms made up of two pieces: connect the uni-
6.
versal joint (E) into the free ends of the two booms, align-
ing the holes correctly; loosen the three screws of the joint
equally so that the latter can be fastened inside the booms
23
lightly oil the aluminium rail on both sides
7.
8. along the entire length of the boom, insert the rubber im-
pact protectors through the slots (F) alternating them with
the relevant joints (G); the rubber protector can protrude
roughly 1 cm from the end of the boom
24
F
G
12 – ENGLISH
E
E
F
G
F
put on the boom cap (H) and secure it with the two screws
9.
position and fit together the two rubber protector caps (I)
10.
25
insert the complete boom into the shell (J) of the support
11.
all the way to the end
vigorously tighten the 6 screws of the support inserted
12.
previously.
26
F
F
l
After installing the boom and the rubber impact pro-
tector, before proceeding further, the other acces-
sories – if relevant – must be installed on the boom.
To install them, refer to the respective instruction
manuals.
H
I
J