Cisco ASR 14000 Series Management Command Reference page 166

set default-safi
set default-safi
To set the default subaddress family identifier (SAFI) for the current session, use the set default-safi
command in EXEC mode.
Syntax Description
all
multicast
unicast
Defaults The default SAFI setting is set to unicast for all sessions.
Command Modes
EXEC
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the set default-safi command to set the default SAFI setting for the current session. This command
acts as a keystroke shortcut for show commands. If the default SAFI setting is set to unicast, you would
not have to specify the unicast keyword for show commands that support that keyword. For example, if
the default SAFI setting is set to unicast, you could issue the show route command without specifying
the unicast keyword to display information about unicast address prefixes in the Routing Information
Base (RIB).
Use the
Task ID Task ID
basic-services
Examples The following example shows how to set the default SAFI to multicast:
RP/0/RP0/CPU0:router# set default-safi multicast
%% Default Sub-Address Family Identifier is set to 'multicast'
Cisco ASR 14000 Series Router System Management Command Reference
SMR-164
set default-safi {all | multicast | unicast}
Sets the default SAFI to multicast and unicast for the current session.
Sets the default SAFI to multicast for the current session.
Sets the default SAFI to unicast for the current session. This is the default
setting.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
show default-afi-safi-vrf
Operations
read, write
Configuration Management Commands on Cisco IOS XR Software
command to display the default SAFI setting.
OL-17231-01