Replacing the power-button board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in
in
After working inside your
www.dell.com/regulatory_compliance.
Procedure
1
Align and slide the power-button board on the power-button board bracket and snap it into place.
2
Align the screw holes on the power-button module with the screw holes on the top cover.
3
Replace the two screws (M3x4) that secure the power-button module to the top cover.
4
Route the power-button module cable through the routing guide on the top cover.
Post-requisites
1
Replace the
top
cover.
2
Replace the
right-side
3
Replace the
left-side
96
Before working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
cover.
cover.
computer. After working inside your computer, follow the instructions