Arrma 4x4 BLX Get Started page 12

Battery Modes
If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Temperature Protection
If the ESC temperature exceeds 105 degrees Celsius/221 degrees Fahrenheit, the ESC
will enter temperature protection mode and the red status LED will blink. Once the ESC has
cooled down it will resume normal operation.
ESC Tuning Options
The ARRMA BLX brushless ESC is setup for use straight from the factory, if you want to alter the
settings for your track or driving style please see the table and steps below:
Variable
1 Low Voltage Cut-Off Threshold
2 Punch Setting
3 Brake Strength
4 Running Mode
5 Motor Rotation
A
Connect a battery. Press and
hold the set button and turn on
ESC. The RED LED will flash.
Using the tuning chart, press the
'set' button until the number of
red LED flashes and short beeps
equals the required value.
© 2018 ARRMA RC. A trade name of Horizon Hobby Ltd
Setting > 1 2
LIPO NIMH
Level 1 Level 2
25% 37.5%
Fwd/Brk/Rev Fwd/Brk
Normal Reverse
(CCW) (CW)
B
Keep holding the set button and
you will see the GREEN LED
flash/beep (the number of green
flashes represents the variable
number).
To save the setting, switch the
ESC off. Restart the process to
make more changes.
12
3 4 5
Level 3 Level 4 Level 5
50% 62.5% 75%
To enter the selected variable,
release the set button on the
desired number of flashes/
beeps.
6 7
87.5% 100%