Installation - AEG FSE83806P User Manual

22 www.aeg.com
Electrical connection
Water supply pressure
Water supply
Capacity
1) Refer to the rating plate for other values.
2) If the hot water comes from alternative source of energy (e.g. solar panels), use the hot water supply to
decrease energy consumption.

14. INSTALLATION

There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
Voltage (V)
1)
Frequency (Hz)
Wattage (W)
bar (minimum and maximum)
kPa (minimum and maximum)
Cold water or hot water
Place settings
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Secure dishwasher with
brackets or screws provided
DISHWASHER
Gap on both sides should be
equal, & no greater than
5 mm per side.
If floor is not level, adjust
levelling legs to suit
200 - 240
50 / 60
1550-2200
0.5 - 8
50 - 800
max 60 °C
2)
14
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
SINK
600mm max
300mm min
POWER OUTLET
14.1 Adjusting the height of
the appliance
1. Remove the adjustable plinth.
400mm
min
Min. 400 mm straight
section