AEG FSE83806P User Manual page 24

2. To adjust the front height of the
appliance, turn the 2 front feet
counterclockwise.
3. To adjust the rear height of the
appliance, turn the middle screw
counterclockwise.
14.2 Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly,
loosen or tighten the adjustable feet to
level the appliance.
After adjusting the level of the appliance,
assemble the adjustable plinth on the
appliance.
Once the installation is completed, make
sure that the bottom of the adjustable
plinth is aligned with the floor.
14.3 Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4''.
For best washing performance it is
recommended to connect the appliance
to a cold water supply.
Energy savings can be made by
connecting the appliance to a Solar
water system and using economy
options, however the water temperature
must not exceed 60° C.
Inlet water supply
• Water pressure: 800 kPa max - 50 kPa
min.
• Water flow rate 10 L / minute min.
• If water pressure is in excess of 800
kPa, a pressure reducing valve should
be used. Check for leaks.
• If water temperature is in excess of
60° C, a tempering valve should be
used. Check for leaks.
CAUTION!
Always use new hoses when
you connect the appliance
to the water mains. Old
hoses must not be used. The
water inlet hose must be
examined at an interval of
twelve months for
deterioration and replaced if
necessary.
The water pressure must be in the limits
indicated in the chapter ''TECHNICAL
INFORMATION''. Make sure that the
local water authority gives you the
average mains pressure in your area.
In order to pass the safety valve through
the kitchen cabinets, an opening of at
least 45 mm x 90 mm is needed.
ENGLISH 23