Frequency Modification; Server Status - BITMAIN R4 Manual

5.2 Frequency Modification

You are able to modify the frequency value through ' Configuration->Advanced Settings'. The
default frequency for the R4 server is 600M.

6 Server Status

You can check the operating status of your server on the page below.
ASIC#: Number of chips detected in the chain
Frequency: ASIC frequency setting
GH/S(RT): Hash rate of each hash board
Temp(PCB): Temperature of the hash board, centigrade
Temp(Chip): Temperature of the chips on the hash board, centigrade
ASIC status: 'o' denotes OK, 'x' denotes error '-' denotes dead.
R4 Server Manual
Last updated: 8/30/2016
Page 8 of 11
Page 8 / 11