Setup Menu; Operating Hours - GE ERESCO MF4 Series Operating Manual

3

Setup Menu

Access the setup menu by pressing the OK key and simultaneously turning the key-oper-
ated switch from Stand-By to ON.
The setup menu appears after a few seconds.
Use the arrow keys  and  to select the menu items on this page. If the arrow key  is
pressed in line 09, the next page will be displayed.
With key F3  you can toggle between the pages.
All the menu items can be selected by entering the respective number and pressing the OK
key (e.g. 01 and OK). The current position is displayed inversely.
You can leave the menues by actuating key
NOTE:
01 Operating hours
The operating hours of the digital control and the radiating unit with integrated insert tube
are displayed. Furthermore the serial number of the connected radiating unit and the
integrated insert tube are displayed.
Copyright by GE Sensing & Inspection Technologies GmbH
08/24/2016
6. Edition, ID No.: 37020GB-F
Operating Manual ERESCO MF4 Type Series
If the digital control unit ERESCO MF4 control will be used as stand-alone
equipment (without X-ray unit) e.g. for setting of the parameters of Interface
or Exposure Calculator, following menu items are not available: 01, 02, 04,
05, 08 and 12..
The menu items 09 and 10 can only be selected, if in menu item 14, "control unit
ERESCO MF4 control" is activated as memory location.
F5 at any time.
Bogenstrasse 41 D - 22926 Ahrensburg
41