Connecting To A Power Source - SMC Networks SMC6724AL2 Installation Manual

I
NSTALLING THE

Connecting to a Power Source

To connect a device to a power source:
1. Insert the power cable plug directly into the receptacle located at the
back of the device.
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
receptacle type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is lit. If not, check that the power cable is correctly
plugged in.
3-8
S
WITCH
Figure 3-6. Power Receptacle
100-240V~ 50-60Hz 2A