Instructions - SMC Networks SMC6405TX User Manual

I
NSTALLING THE

Instructions

1. Positioning the Switch: For wall mounting, attach the switch
stand to the wall with two small screws, and then slide the
switch's rear-panel track onto the stand. To stand the switch
upright, slide the base of the switch onto the stand. To lay the
switch flat, slide the switch's rear-panel track onto the stand.
2. Applying Power: Plug one end of the power adapter into the
socket on the switch's side panel, and the other end into an
appropriate electrical outlet. Check the Power LED to be sure
power is on.
Note: It is not necessary to power off the switch before
3. Connecting PCs: Connect each PC to an RJ-45 port on the
switch with a straight-through twisted-pair cable segment,
maximum length 100 meters (328 feet). The EZ Switch 10/100
will support up to 5 PCs.
Note: If an attached device does not support auto-negotiation,
4. Cascading Switches and Other Network Devices: All the
ports on the switch support automatic MDI/MDI-X
configuration for cable connections. This allows you to use
straight-through cable to connect to other switches or hubs
from any port on the switch. No crossover cables or other
device settings are needed. See the "Cable Specifications" and
"Connectivity Guidelines" sections of this guide for further
information.
6
S
WITCH
connecting or disconnecting any UTP cables, as these
actions will not disrupt the operation of other devices
attached to the switch.
the data rate will be sensed automatically and the
communication mode will default to half duplex.