1000Base-T Cable Requirements; Table B-2 1000Base-T Mdi And Mdi-X Port Pinouts - SMC Networks SMC TigerSwitch 10/100 SMC6128L2 Installation Manual

24-port 10/100 mbps fast ethernet managed switch
Hide thumbs Also See for SMC TigerSwitch 10/100 SMC6128L2:
Table of Contents

Advertisement

Table B-2 1000BASE-T MDI and MDI-X Port Pinouts

Pin
MDI Signal Name
1
Bi-directional Data One Plus (BI_D1+)
2
Bi-directional Data One Minus (BI_D1-)
3
Bi-directional Data Two Plus (BI_D2+)
4
Bi-directional Data Three Plus (BI_D3+)
5
Bi-directional Data Three Minus (BI_D3-)
6
Bi-directional Data Two Minus (BI_D2-)
7
Bi-directional Data Four Plus (BI_D4+)
8
Bi-directional Data Four Minus (BI_D4-)

1000BASE-T Cable Requirements

All Category 5 UTP cables that are used for 100BASE-TX connections
should also work for 1000BASE-T, providing that all four wire pairs are
connected. However, it is recommended that for all critical connections, or
any new cable installations, Category 5e (enhanced Category 5) or
Category 6 cable should be used. The Category 5e and 6 specifications
include test parameters that are only recommendations for Category 5.
Therefore, the first step in preparing existing Category 5 cabling for
running 1000BASE-T is a simple test of the cable installation to be sure
that it complies with the IEEE 802.3-2005 standards.
Cable Testing for Existing Category 5 Cable
Installed Category 5 cabling must pass tests for Attenuation, Near-End
Crosstalk (NEXT), and Far-End Crosstalk (FEXT). This cable testing
information is specified in the ANSI/TIA/EIA-TSB-67 standard.
Additionally, cables must also pass test parameters for Return Loss and
Equal-Level Far-End Crosstalk (ELFEXT). These tests are specified in the
ANSI/TIA/EIA-TSB-95 Bulletin, "The Additional Transmission
Performance Guidelines for 100 Ohm 4-Pair Category 5 Cabling."
T
-P
C
WISTED
AIR
MDI-X Signal Name
Bi-directional Data Two Plus (BI_D2+)
Bi-directional Data Two Minus (BI_D2-)
Bi-directional Data One Plus (BI_D1+)
Bi-directional Data Four Plus (BI_D4+)
Bi-directional Data Four Minus (BI_D4-)
Bi-directional Data One Minus (BI_D1-)
Bi-directional Data Three Plus (BI_D3+)
Bi-directional Data Three Minus (BI_D3-)
P
A
ABLE AND
IN
SSIGNMENTS
B-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

6128l2

Table of Contents