Getting To Know Your Z1 Cpap System; Package Contents; Z1 Cpap Device; Power Supply (Ac To Dc Power Adapter) - Human Design Medical Z1 CPAP System User Manual

• Do not attach the Battery directly to a vehicle cigarette lighter or to the Power Supply plug .
• Do not continue charging the Battery if it does not recharge within the specified charging
time . Doing so may cause the Battery to become hot, rupture or ignite .
• Remove the Battery from the PowerShell if the Z1 is not likely to be used for some time . Do
not use the Battery to power any device other than the Z1 .
• Only use or charge the Battery within the operating temperature, humidity and altitude
conditions specified in the Technical Specifications section of this User Guide .
• Only store or transport the Battery within the storage and transport temperature and
humidity conditions specified in the Technical Specifications section of this User Guide .
CAUTION:
• When the Battery is worn out, insulate the terminals with adhesive tape or similar
materials before disposal .

Getting to Know Your Z1 CPAP System

Package Contents

Z1 CPAP Base Model

Z1 CPAP Device

Power Supply & Cord
Custom USB A to Micro B Cable
Custom CPAP Tube Adapter
48" Slim Style CPAP Tube

End Cap

Filter (2- 1 installed in Z1, 1 in box)
Heat / Moisture Exchanger (HME)
Z1 Auto Getting Started Guide
Z1 Auto User Guide
Z1 CPAP Device
The Z1 supplies continuous positive airway pressure and can be programmed to fit the patient's
prescriptive needs .

Power Supply (AC to DC Power Adapter)

The Power Supply provides power to the Z1 . It takes AC power (voltage ranging from 100-240
volts) from a wall outlet and converts it to DC voltage to power the Z1 . The Power Supply can be
used with international power sources provided the appropriate plug adapter is used .

Tube Adapter

The Tube Adapter attaches the CPAP Tube to the Z1 .
8
PowerShell Module
Extended Life Battery
Battery Shuttle
PowerShell
PowerShell Getting Started Guide
HME
Slim-style

CPAP tube

CPAP Tube
The Z1 System is provided with a 4 ft slim style CPAP Tube . The CPAP Tube connects the Z1 to your
mask . Always consult with your physician or health care provider regarding the selection of tubing
for your treatment . Follow the instructions provided with the tubing .
End Cap
The End Cap attaches to the air intake end of the Z1 and houses the Filter .

Filter

The Z1 uses a specially designed filter . The material has been specifically chosen for the Z1 and
has been designed to be much larger than other CPAP filters . The unique shape of the filter fits
into the End Cap of the Z1, which was designed to allow for more effective filter surface area .
For proper operation of the Z1, the Filter should be replaced monthly or more often if necessary .

USB Micro Cable

The USB Cable allows the Z1 to communicate with a computer to collect and view user data .

Heat Moisture Exchanger (HME)

The disposable HME works by capturing moisture as you exhale and provides it back to you
as you breathe . The HME does not use any electricity or complex moving parts and avoids the
problems encountered with electrical humidification systems .
To install the HME, connect the large diameter end of the HME to your mask and the smaller
diameter end to your CPAP Tube . Be sure both connections are fully seated and secure . Store the
HME in a sealed plastic bag between uses to extend its life . Discard when it is no longer providing
humidification .

PowerShell (Optional Accessory)

The PowerShell houses both the Z1 and the Battery which allows temporary usage of the Z1
without the Power Supply . It can be purchased at your retail medical supplier or at www . h dmusa .
com .
Power Cord
USB Cable
AC DC Adapter
Filter
Tube Adapter
Z1 CPAP
9