Set Up Guide; Unpacking The Z1 Box; Assembling And Powering Up - Human Design Medical Z1 CPAP System User Manual

Set Up Guide

Unpacking the Z1 Box

You will need to perform a few minor setup steps before using your new Z1 . The instructions
below will guide you through the setup process . Some of the steps outlined below may have
been performed by your health care provider prior to delivering the Z1 to you . If you have any
questions or problems as you go through the setup process, please call Human Design Medical
Customer Service at 1-855-436-8724 for assistance . Human Design Medical wants your user
experience with the Z1 to be trouble and frustration free .
1 . Carefully remove the contents of the box .
2 . Some of the Z1 components have their own packaging material . Remove this material
carefully . Avoid using anything sharp when opening the packaging .
3 . Carefully inspect all contents against the Package Contents list on page 8 to assure
all components are present . Keep in mind that your health care provider might have
completed some of the setup steps prior to delivery, so if a component appears to
be missing, check to see if it has already been connected . Also inspect all contents to
ensure there is no obvious or visible damage or defects . If you have any concerns or
questions, contact Human Design Medical Customer Service at 1-855-436-8724, or
your service or health care provider before use .
4 . Place all the components in an area where you can easily access the Z1 for set up and
programming .
WARNING: Do not use this product if you have any concerns about the
condition of the contents or if there are any missing parts .
Z1 Base Model

Assembling and Powering Up

Filter and End Cap
Your Z1 comes with the first filter already installed . Replacement
filters may be installed as follows:
1 . Remove the Filter out of the End Cap.
NOTE: To remove the End Cap, squeeze
firmly on the sides of the End Cap and pull
it away from the Z1 .
2 . Pull used filter out of the End Cap.
3 . Remove new Filter from its packaging .
4 . Insert the new Filter into the End Cap, aligning the
arched side of the Filter with the top of the End Cap .
Ensure the Filter covers all holes in the End Cap, so
that all air entering the Z1 passes through the Filter
and no air bypasses the Filter .
5 . Press the End Cap onto the Z1 . (Figure 1)
10
Tube Adapter, CPAP Tube, HME and Mask
1 . Connect one end of the CPAP Tube to the round end of
the Tube Adapter then insert the other end of the Tube
Adapter into the outlet of the Z1 . (Figure 2)
2 . Connect the other end of the CPAP Tube to the HME
and the HME to the mask .
3 . Ensure all connections are tight to avoid air leaks .
(Figure 3)
Power Supply
WARNING:
with the Human Design Medical Power
Supply (or the optional Human Design
Medical PowerShell with Human Design
Medical Battery) . DO NOT use any other
power source with the Z1 .
IS NOT plugged into an AC power outlet
before continuing to the next step .
1 . Plug the AC power cord into the AC Adapter .
2 . Plug the AC power cord into a wall outlet .
3 . Plug the AC Adapter into the Z1 . (Figure 4)
4 . The Z1 will power up and cycle through a series of
startup displays .
5 . After about 10 seconds, the Z1 will enter standby
mode . The display will read 0 . 0 . (Figure 5)
NOTE: The Z1 display will be active
whenever the device is receiving power .
HME
Slim-style
CPAP tube
Figure 1
The Z1 must only be used
CAUTION:
Make sure the AC power cord
Mask (not included)
Tube Adapter
Z1 CPAP
Figure 2
Figure 3
Figure 4
Figure 5
11