Uwatec Z1 User Manual page 82

24. Care & Maintenance
How to Care for Your Z1
• Frequently wipe away dirt, sweat, moisture, etc., with a soft cloth.
• After use in salt water or in close proximity to mud, rinse thoroughly with
fresh water after a short freshwater soak.
• For the metal components of both the metal band and resin band, scrub
with a soft toothbrush and soapy water. Then rinse well with fresh water
and wipe off residual moisture with a soft hygroscopic cloth.
• Wash the resin band with fresh water and wipe off residual moisture
with a soft cloth. You may fi nd a spot-like pattern on the surface of the
resin band; however, there is no eff ect on the human body and clothing.
• If you do not operate the buttons for a long time, their movement may
become stiff . From time to time, press the buttons to loosen up the but-
ton action.
Failure to Care for Your Z1
Rust
• The metal used on the Z1 is rust-resistant, but rust can be caused by
dirt. (When oxygen is cut off due to dirt, the oxide fi lm on the surface
cannot be maintained and rust occurs.)
• If rust occurs, a sharp point may be formed in the metal parts, or the
wristband pin may pop out. If you notice any abnormality in metal parts,
return your Z1 immediately to your dealer for repair.
• Even if the surface of your Z1 appears clean, dirt and rust can collect in
crevices which can potentially soil the sleeves of clothing, cause a skin
rash, or deteriorate the performance of your Z1.
Deterioration
• Allowing your Z1 to remain wet from moisture such as sweat, or storing
it in a humid place, can cause deterioration of the resin band and resin
bezel, increasing the possibility of a breakdown.
Rash
• Depending on the condition of your Z1 and the condition of your skin, the
wristband – especially a resin band – can cause a rash. Always keep your
Z1 clean and dry. If you do get a rash, stop wearing your Z1 and consult a
dermatologist.
82