Table of Contents
Advertisement
2. Press-and-hold the ADJUST button for about 2 seconds.
After [SET] [Hold] blinks, release the button when you see [GAS1] [21 -
100%].
(If the Gauge Mode is set to ON, at this point it will switch to the inter-
val alarm screen immediately, in which case you can move directly to
Step 5.)
3. Press the ADJUST button 2 to 4 times to reach the display for Safety
Factor setting.
4. Press the ADJUST button again to switch to the depth interval alarm
screen.
5. Press the ADJUST button again to switch to the maximum depth warn-
ing [DEEP] setting.
6. Press the PLAN button to increase depths in increments of 1 meter
when set to metric, or increments of 5 feet when set to imperial. You
can also press the LED/LOG button to decrease depths. (When us-
ing meters: OFF/3/4/5...98/99m. When using feet: OFF/10/15/20...
320/325ft.
7. Press-and-hold the MODE button for about 2 seconds to return to
Watch Mode or Surface Mode.
The Alarm Function
•
An alarm will sound if the set depth is
exceeded. It also blinks when the depth is
above the set depth.
•
Once it reaches the set depth, it will be
entered into the log (when diving in normal
Dive Mode).
57
Advertisement
Table of Contents
