Table of Contents
Advertisement
Display
Dive time
GAUGE
Depth
Max depth (MAX)
Water temperature
Compass Bearing
Stopwatch
19-3. Turning Gauge Mode Off
1. In Watch Mode or Surface Mode, press the PLAN button to go to Plan
Mode.
2. Press-and-hold the ADJUST button for about 2 seconds. After [SET]
[Hold] blinks, release the button when a blinking [INT] appears.
3. Press-and-hold the ADJUST button again for about 2 seconds. Gauge
[SET] [ON] blinks.
4. Press the PLAN button to select [GAUGE] [SET] [OFF]
5. Press the ADJUST button to save the new setting.
6. Press-and-hold the MODE button for about 2 seconds to return to
Watch Mode or Surface Mode.
NOTE: When you select Gauge Mode and dive for 3 minutes or more, the
unit is locked to Gauge Mode for 48 hours after the dive ends and you can-
not switch to Dive Mode (computer function) or Freedive Mode. If Gauge
Mode is turned ON, Safety Factor and O
Time elapsed from diving start *Max. 599 min
Current depth resolution is 0.1m (1ft)
*Max 99.9m/328ft
Maximum water depth in the dive *Max 99.9m/328ft
Display current water temperature
Ref. Digital compass• • • P.58
Display elapsed time up to 0.1 second increments• • •
% are not displayed.
2
73
Title
P.61
Advertisement
Table of Contents
