SMC Networks Barricade SMC2404WBR User Manual page 103

BACK - FAQ - Disable Dial-up and Proxy
Network Interface Cards - What adapter are you using?
The following section is very helpful in the event that you cannot connect to
the router interface. This will show you how to change the actual speed of
your adapter and properly identify its Make/Model. You will also want to
have this information handy if you need to contact Technical Services for any
reason.
Windows 9x/Me
§
Click "Start", and then go to "Settings" and click on "Control Panel". Double-
click the "Network" Icon and then you will see a list of adapters. Usually the
network interface card will include 10/100 or LAN in its actual name.
§
If you have a problem connecting to the router interface, there may be a
problem with the auto negotiation features of your adapter. In this case you would
need to hard-set the speed of the adapter. To do this, double-click on its name in
"Network" and go to the Advanced tab. Look through each setting and change the
"media type" or "link speed" to 10Mb Half Duplex/10BaseT. Then press OK to
save the changes.
§
To continue installing the router, click here.
Windows NT
§
Right-click the "Network" icon on your desktop and go to the "Adapters" tab.
Then you may see a list of adapters. Usually the network interface card will
include 10/100 or LAN in its actual name.
§
If you have a problem connecting to the router interface, there may be a
problem with the auto negotiation features of your adapter. In this case, you would
need to hard-set the speed of the adapter. To do this, double-click on its name
under this "Adapters" tab and change the speed to 10Mb Half Duplex/10BaseT.
Then save the changes. The system may need to be restarted afterwards.
NEXT - FAQ - Software Conflicts