Table of Contents
Advertisement
Inclinometer Assembly
Martin Audio supplies an optional remote angle monitoring system which can used to reliably check the angle at which the WPL array is
flown (relative to the horizontal). It consists of a sensor (mounted within the flying frame) and a remote display unit. Interconnection is via
a standard XLR mic cable.
Fitting the inclinometer sensor to the flying frame
The WPL touring flying grid may be fitted with an inclinometer sensor which is available as an optional accessory part number ASM20017.
Once coupled with the ASM20019 inclinometer read-out display via a standard 3-pin XLR mic cable, precise measurements of the angle
of the array can be taken to ensure that the DISPLAY optimisation is as accurate as possible.
The touring flying frame part number WPLGRIDt has a mounting bracket with M4 threaded holes ready to accept the sensor (fig 11).
The sensor is housed in a rugged weatherproof diecast aluminium enclosure. Fitting the sensor is a very quick and easy job requiring just
two tools, a 3mm allen key (wrench) and a PZ2 Pozidrive screwdriver.
Remove the lid
The sensor is attached to the grid with two M4 cap head screws which have to be inserted through pre-drilled holes in the box. To access
these it is necessary to remove the lid of the box (fig. 12).
WPL USER GUIDE V1.0
Copyright © 2019 Martin Audio Ltd.
fig. 11
fig. 12
20
WPL USER GUIDE
Advertisement
Table of Contents
